NetTalk Central
The Rest Of NetTalk => The Rest - Ask For Help => Topic started by: Rakesh on April 13, 2022, 12:27:10 PM
-
Hello -
I'm using Nettalk 12.35 in a multi DLL project. In when compiling a on of the DLL, I'm getting hundred's of duplicate warning for these EQUATES
SO_DEBUG EQUATE(01h) ! turn on debugging info recording
SO_ACCEPTCONN EQUATE(02h) ! socket has had listen()
SO_REUSEADDR EQUATE(04h) ! allow local address reuse
SO_KEEPALIVE EQUATE(08h) ! keep connections alive
SO_DONTROUTE EQUATE(010h) ! just use interface addresses
SO_BROADCAST EQUATE(020h) ! permit sending of broadcast msgs
SO_USELOOPBACK EQUATE(040h) ! bypass hardware when possible
SO_LINGER EQUATE(080h) ! linger on close if data present
SO_OOBINLINE EQUATE(0100h) ! leave received OOB data in line
These are part of NetAll.inc and WINSOCK.INC (sv). Any suggestion how to avoid these?
(Error detail image attached)
Thanks,
-Rakesh
-
I'll look into it - but it begs the question - if you are using NetTalk, then why are you including winSock.Inc?
Are you using something that drags that in?
-
Hi Bruce,
Here's some additional information - I'm in the process of swapping out SV Comm templates that I was using for Emails with NetTalk. In one of the APPs, I have both extensions present, thus this winsock.inc got included by SV Extension. I hope once I completely remove SV comm extensions, this dup error should go away. Since this is a just a "warning" message per say, its not a critical blocker.
-Rakesh
-
I've tweaked the code for 12.40 so it'll go away there. In the meantime just ignore it.
Cheers
Bruce